Did it ever run properly or was this a problem since the mods?

 

Ran great, just started.

 

The protected circuit is identified as PCM vehicle power 4 – ignition coil. My guess would be it has to do with your Vampire controller and/or lean control module. I'd contact both vendors and ask them if they have a solution. It could be as simple as a higher amped fuse, but let them tell you that.

 

Thank you for the reply, I will be reaching out to them today😫. It is driving me crazy!!

 

You may have to use only one of those devices, so if neither has a solution, try them one at a time and to see if it still blows fuses. If both check out okay, you may have to choose one over the other.

 

Well, a phone call is not working to either manufacture. Not too sure about just unplugging them for fear of timing being pulled, any suggestions are welcome!
Thanks

 

Update, I unplugged the power to the Safeguard Vampire controller and the the fuse has not blown (Yet) . I am in Alabama does anyone know someone who knows these cars that can dyno and tune this car? Driving to them is not a problem.
As always thanks to the guys for your help!

 

Update, I unplugged the power to the Safeguard Vampire controller and the the fuse has not blown (Yet) . I am in Alabama does anyone know someone who knows these cars that can dyno and tune this car? Driving to them is not a problem.
As always thanks to the guys for your help!

I

hey man how you been? You get the rear end fixed from the boo boo at Ponies In The Smokies? Not sure of a good tuner in Bama but here in NC National Speed and ProDyno are tops on the 500

 

Sorry you did not get through when you called. Did you send an email?

Do you still have the Vampire? Is it installed and working correctly?

If not, send it in and I will test it for a shorted output. I'll also load the latest software at no charge. Just pay return shipping of $11.

Send only the Vampire box please. No need to send the whole kit.

 

Thank you for your response please send me an address and I will send it to you. If I you have a number as well I would like to call you to discuss. Thanks again!

 

Please send to:

J&S Electronics
13925 Parkway Dr.
Garden Grove, CA 92843

My email address is on the contact page of my website, jandssafeguard.com.

I'll reply with my cell number. The number listed is a spam magnet.

 

Thank you!