Ford Shelby GT500 Forum banner
Status
Not open for further replies.

SC pulley removal tool needed

2007 - 2014 
808 views 1 reply 2 participants last post by  PM-Performance 
#1 · (Edited)
Hello, I am looking to hopefully borrow a VMP/Metco style pulley removal tool to take my Metco 2.6 off. Anyone have one they would loan out for a few $$$? I will never swap pulleys again, going hub style for good so trying to not break down and buy one for a single use. Located in Atlanta, GA if anyone is local as well

Edit: trying to remove the Metco hub and install an OEM pulley. I guess that is a different style tool?
And will I need a tool to Install? thought I could do the oven trick and press it on, no?

Thanks!
 
#2 ·
You need 2 diff tools. I have both as I was in the same boat. I would consider loaning it out, but I would probably want the deposit of a new one and once returned I would refund all but shipping and like $50 just to make sure I get it back.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top