Ford Shelby GT500 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
373 Posts
Discussion Starter #1
Bought this driveshaft awhile back, never installed it, Never even pulled the Driveshaft out of the box. :roller:
Ended up getting one from a performance shop at a... "very" discounted price.

Anyways, $450 + shipping is my asking price.
PM me if you need further details.
 

·
Registered
Joined
·
373 Posts
Discussion Starter #3
Their drive shaft is made of steel 3 inch and is 23 pounds
Dana Spicer 1350 series U-joints which are huge and will handle 1000+ HP
Because shaft is 3 inch if you lower car you will not have any issues.

I know i put aluminum and 3.5" in the topic header... i suck=/
 

·
Registered
Joined
·
267 Posts
Kind of confused as well... You are stating it's a 3" but your topic says 3.5" you state in the topic that it is aluminum but now your saying it's steel.. ???
 

·
Registered
Joined
·
373 Posts
Discussion Starter #6
Sorry.
if you look at the original post i put that it was never taken out of the box, and the driveshaft i had ended up getting on my shelby is a 3.5" aluminum shaft...

it's not that hard to follow the logical order is it?

The shaft is a 3" steel shaft that is 23lb (my 3.5" aluminum is 24ish).

if you do research the first batch of these shafts had problems from not using a solid tube (broke at the weld). This is part of the second batch, is a solid shaft, and per interest i have taken it out of the box (when i figured out it wasn't 3" or aluminum).

Sorry for the confusion, and i hope you understand now.
 

·
Registered
Joined
·
373 Posts
Discussion Starter #7
Now I'm confused. What kind of DS are you selling? Any details on it?
the details you asked for are above...

if anyone wants pictures, i have a 7ish. including sales receipt, etc.
 

·
Registered
Joined
·
373 Posts
Discussion Starter #8
Sold!!
 
1 - 8 of 8 Posts
Top