Ford Shelby GT500 Forum banner

1 - 8 of 8 Posts

·
Premium Member
Joined
·
865 Posts
Discussion Starter #1
who has installed one and are you satisfied? Any tips? One is on the way and should have it ready for install next week. Thanks.
 

·
Registered
Joined
·
1,382 Posts
if its the one piece alum dynotech...then your golden...pretty straight forward install. just make sure to evenly torque the adapter bolts, then DS bolts. (star pattern & cris-cross), and apply torque in increments, 25lb each until full torque is reached is normal.
 

·
Premium Member
Joined
·
865 Posts
Discussion Starter #3
I am not sure if EVO has dynotech, I know Lethal does. Can anyone chime in?
 

·
Registered
Joined
·
2,400 Posts
I am not sure if EVO has dynotech, I know Lethal does. Can anyone chime in?
Do not know about their current DS of choice, but mine from EVO, way back, was Dynotech and no complaints here.
 

·
Premium Member
Joined
·
252 Posts
What is the torque spec. for the 4 driveshaft bolts? I recently installed a driveshaft safety loop and the instructions said to torque the transmission bolts to 55 ft/lbs but just said to retighten the 4 driveshaft bolts!
 

·
Registered
Joined
·
1,382 Posts
What is the torque spec. for the 4 driveshaft bolts? I recently installed a driveshaft safety loop and the instructions said to torque the thansmission bolts to 55 ft/lbs but just said to retighten the 4 driveshaft bolts!
the four DS bolts at the tranny are 76 ft/lb
the six bolts for the DS adapter at the pinon are 25 ft/lb
the four bolts for the DS at the pinion are 35 ft/lb
 
1 - 8 of 8 Posts
Top