Ford Shelby GT500 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
246 Posts
Discussion Starter #1 (Edited)
F/s:

Bassani axle back, p/n: BAS-46075

4" Polished, rolled edge tips w/Bassani laser-etched into the top edge.

Cans are freshly polished, no structural damage and very little mileage. Tips are in great condition (like new overall). I'd rate them 9.5/10 just because they've got a little mileage on them.

I purchased these used, polished them, put them on for about 20mins and took them back off. Not quite loud enough for me.

Apparently you have to remove the alignment "pin" on the factory tailpipes to slip these on. Whoever had them before cut a slot for the pin on the driver's side pipe, but not the passenger; just FYI. Has no effect on the installation of the system, just something to note.

Sound wise, these would fall between the FRPP SVT-1 (Borla touring) and the FRPP SGT/5GT (Borla Stinger) systems. Great sound overall, not obnoxious at any time and total volume is really close to being exactly between the two aforementioned systems.

Pics to come later.

$455 delivered in Cont. US.

Paypal or M.O. accepted; PM if interested.

Will trade for FRPP SGT/5GT systems, Steeda Axle back or Boom Tubes.

PICS:





 

·
Registered
Joined
·
246 Posts
Discussion Starter #2
Pics added.

Please note the surface facing of the end of the cans (next to the tips) looks good. The milky spot is a hand print.
 
1 - 2 of 2 Posts
Top