On my Raptor "dual mode" launch/shift light operating instructions, it referes to hooking up the red to a switched and fused 12 volt source, green to the tach outlet lead or the switched side of the ignition coil (negative side), and the white to the vehicle speed signal (vss) output from the ecu. Where the hell are these areas? The black goes to any suitable ground. I would love to install myself without hiring a pro.

Ended up hiring an excellent man from my local dealership to come to my house and finish the install. Had already ran the wires throught the fire wall. Have the limits set on 2500 for the hole shot and 6000 for top end. Will adjust as needed. Only cost me $50. Love the look on top of my dash!!!

Pictures?

Ended up hiring an excellent man from my local dealership to come to my house and finish the install. Had already ran the wires throught the fire wall. Have the limits set on 2500 for the hole shot and 6000 for top end. Will adjust as needed. Only cost me $50. Love the look on top of my dash!!!
If you get a chance post a pic or two.

I need one of those; it's hard for me to watch the road & the tach.

Thanks!

Yes pics plz

On my Raptor "dual mode" launch/shift light operating instructions, it referes to hooking up the red to a switched and fused 12 volt source, green to the tach outlet lead or the switched side of the ignition coil (negative side), and the white to the vehicle speed signal (vss) output from the ecu. Where the hell are these areas? The black goes to any suitable ground. I would love to install myself without hiring a pro.


2,500!? C'mon....light 'em up!!

:rofl:

BJ