milezperhour
09-24-2007, 02:38 PM
Requesting assistance....
Installed the driver side, pretty easy. Started the pass side, and bolt hole was off, so i adj to compensate...stupid me...now the axle has shifted 1 inch aft. Looking for best method to get the axle back forward enough to get the last bolt in. Hanging out perplexed......and pissed at myself.
shlbysvt
09-24-2007, 03:06 PM
Requesting assistance....
Installed the driver side, pretty easy. Started the pass side, and bolt hole was off, so i adj to compensate...stupid me...now the axle has shifted 1 inch aft. Looking for best method to get the axle back forward enough to get the last bolt in. Hanging out perplexed......and pissed at myself.
Common if you do not remove and install under a load, or if you change the load once the lca is removed. One method is to install a small hand hydraulic jack between the lca mounts and some blocks of wood between the two points. This works it it shifted forward as it usually does.
milezperhour
09-24-2007, 04:31 PM
Common if you do not remove and install under a load, or if you change the load once the lca is removed. One method is to install a small hand hydraulic jack between the lca mounts and some blocks of wood between the two points. This works it it shifted forward as it usually does.
Thanks. Not sure what your meaning (between the mounts, and between two points). I was thinking of lifting at the frame just forward of the axle removing the load.
milezperhour
09-24-2007, 06:06 PM
DEAD thread.....all resolved. Thanks shlbysvt
07 SHELBY
09-24-2007, 06:17 PM
DEAD thread.....all resolved. Thanks shlbysvt
Glad you got it:D :D Good job Joe:D :D :D
milezperhour
09-24-2007, 09:12 PM
Glad you got it:D :D Good job Joe:D :D :D
Yea, i feel better and more relaxed. Glad we can all rely on one another here.
CajunCobra
09-25-2007, 08:41 PM
Ok
Now all we need is a test drive and personal evaluation. Are you doing this for wheel hop or side G's? Urethane bushings? How's the ride?
milezperhour
09-26-2007, 01:06 PM
Drove her yesterday and played a bit. Felt real good. Could actual feel the difference, and the tires grabbing better, but haven't hit it hard yet....that's today near sunset. I did install an extra spacer on the front mounts (same size as the washers provided) since there was a gap. This kit (4406) didn't come with one, but it is needed. The washers that came with were uesd on the rear mounts, one each side.