1pc drive shaft and loop [Archive] - Ford Shelby Cobra GT500 Forum

: 1pc drive shaft and loop


gt500man
09-09-2007, 05:22 PM
who makes a bolton drive shaft loop and 1pc drive shaft for my 07 shelby.
where do i buy it?

bogey1222
09-09-2007, 06:15 PM
who makes a bolton drive shaft loop and 1pc drive shaft for my 07 shelby.
where do i buy it?

http://www.evoperform.com/shop/ They have an Aluminum made by dynotech! Have on on mine. Weighs less than half the stock shaft.

flipmo
09-10-2007, 02:11 PM
who makes a bolton drive shaft loop and 1pc drive shaft for my 07 shelby.
where do i buy it?

Welcome to the board GT500man. Have fun! Oh, BMR fabrication also makes a loop. I asked this last week. However, if you purchase from Evo I'm sure they will give you a deal on the combo.

Good Luck

flip

Arbour88
06-15-2009, 10:54 AM
The last drivng instructor I had was really rude and impatient with me so I'm looking for someone with a gentle and relaxing attitude, any answers would be much appreciated.

How is this comment related to the thread?

Arbour88

subsailor
06-15-2009, 02:03 PM
How is this comment related to the thread?

Arbour88

lol, see my other post about spammers....... i have learned to ignore them.

Attn: Moderator

is there any way to remove them?

VNMOUS1
06-15-2009, 05:31 PM
How is this comment related to the thread?

Arbour88

No kidding.......

Did I ride my bike today or did I bring my lunch?

Who IS this noob?

bj

goldgus
06-15-2009, 07:10 PM
:rofl::rofl::rofl::rofl::rofl:

subsailor
06-15-2009, 07:28 PM
No kidding.......

Did I ride my bike today or did I bring my lunch?

Who IS this noob?

bj

BJ you kill me, i look forward to your posts! lol

fghtrpilot
06-15-2009, 07:48 PM
The last drivng instructor I had was really rude and impatient with me so I'm looking for someone with a gentle and relaxing attitude, any answers would be much appreciated.

Ignore BJ,

I'll instruct you for $500 an hour you farking noob!

(expenses not included and I tend to backslap in the face for any mistakes or if I just feel like it.)

:rofl:

VNMOUS1
06-18-2009, 11:08 PM
Ignore BJ,

I'll instruct you for $500 an hour you farking noob!

(expenses not included and I tend to backslap in the face for any mistakes or if I just feel like it.)

:rofl:

That's right, FGHTRPILOT will give you the loving care you so deserve (and he SO loves to dish out). Be careful, though, when he breaks into a monologue about P-Factor and St. Elmo's Fire. You'll come out of it a new man and a seasoned drag racer.

:silly:

bj